Branches should be taken back to their point of origin or to laterals that are at least one-third the diameter of the limb being removed. Also, remove branches with narrow angles of attachment that are prone to breaking under heavy nut load, in wind storms and even from snow load. Keep in mind that after 3 to 5 years of training young trees through pruning, The focus of most of the pruning will simply be removing dead, broken, and weak branches and maintaining the desired tree structure through occasional shaping cuts by selectively remove limbs from the perimeter of the canopy, especially those growing close together or beyond the desired canopy size. Two orchards with trees approximately the same age, but managed differently. The orchard in the top picture has never been pruned, the trees in the bottom picture have been pruned regularly. You should be able to see the difficulties one will have training this relatively older tree, that since its planting, became stunted and dwarfed due to vigorous branches. An 8-year-old European X Japanese hybrid that has never been pruned since planting. A well-pruned orchard will ensure good orchard management. Remember that the primary objective of pruning a young orchard is to develop a strong tree framework that will support nut production. Pruning of young trees should be done in the winter when possible but may require summer pruning when problems emerge. Photo 4. Starting with quality, balanced trees makes pruning a lit easier. Notice the small growth tube which is acting as a tree (mouse) guard, not a growth tube. The Photo shows the “before” and “after” pruning process. Pruning demonstration in a grower’s orchard where a discussion ensues about the pruning the tree is about to have. These branches are too low to maintain a good shape to the tree, which needs to be trained “upward.” The following year the lateral branches under the main leader stem will be removed even though they have burs. A tree similar to that in Photo 1 but in this case, the two-year-old tree received early pruning. In its second year, a severe crotch has developed, making it difficult to tell which stem is the leader. Secondary branches are taking over the central leader, as the tree was never trained. A two-year-old chestnut tree, planted without any pruning. If using a mechanical harvester or a sprayer, consider what kind of clearance is needed to allow easy access or workers and equipment. Accessibility to the orchard should also be considered when pruning. If they are essentially equal, either can be removed. When a young tree has competing leaders, the weaker ones should be removed. Most trees are grown with one central leader (the top most vertical branch). The objective in the first few years is to identify and correct problems with the main framework of the tree. Training should take place gradually over several years and no more pruning should be done than is necessary to enhance the natural shape or structural strength of the tree (Photo 2). Pruning and training of a young tree should begin the first year after transplanting. The shoot, which you are pushing, will become an extension of the main stem.īranches smaller than ½ the size of the main stem can stay, as they do not significantly reduce the amount of water to the top of the tree (Photo 2). Any stem over ½ the size of the main stem is stealing water from the main stem you are trying to push. Any stems greater than ½ the size of the main stem should be considered “leaks” in the main water pipe (see pic). To achieve both shape and good production, think of the root system of the new tree as a water pump. Though this work focuses on Japanese chestnuts ( Castanea crenata), the concepts are applicable for the European x Japanese hybrids ( C. Hitoshi Araki from the Hyogo Research Institute. As the orchard matures, maintenance cuts are made to remove dead branches, undesirable branch angles and overlapping canopies between neighboring trees.Īs a good introduction to pruning chestnuts, check out this great article, Pruning Chestnuts for Improved Productivity by Peter Hall, summarizing the work of Dr. Early in the life of an orchard, pruning cuts are made to develop the desired structure of the tree. Sometimes it seems these are in conflict, as most pruning will initially reduce production, but if done correctly pruning increases productivity over time. There are two primary reasons to prune chestnut trees, 1) to develop the shape you need, and 2) to optimize productivity. Pruning chestnuts is an important part of healthy orchard maintenance.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |